RedStickReefer 319 Report post Posted March 8, 2019 Oh, I also did a quick video update on the 180g to give an overview of where I'm at so far. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted March 10, 2019 SPS haul from Fragniappe today. Shout out to @lars for not buying up all of the Fraghouse SPS before I had a chance to get my hands on a few. From left to right: Walt Disney, FHC Heat Sink Mille, Dippin Dots, FHC Game Over Mille, JF Sour Twist, and in the back right is JF Fox Flame. I just hope I can keep them this colored up in the 30g. Awesome selection of SPS from Fraghouse, Top Shelf Aquatics and other vendors today. The Fragniappe SPS game has definitely been on point the last couple of years. Come a long way from our first Fragniappe event! 2019-03-09_06-15-57 by Jensen Esneault, on Flickr Quote Share this post Link to post Share on other sites
lars 230 Report post Posted March 13, 2019 You are welcome. I did buy four from him though. Great guy and vendor. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted April 28, 2019 Sorry guys, not much to update on the 180g. Been working a lot and got hit pretty hard by the IRS. Still going to move forward though, just going to take more time. I have picked up some frags recently though from Adam and top shelf aquatics. I picked up a Diablo mille and ASD rainbow mille from Adam. The group of frags in the pic below from top shelf aquatics are the JF Shocktart, Paletta pink tip, ora red table, jkr rainbow acro, and the one in the middle back is a bill Murray. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted April 28, 2019 Ignore the middle pic. I can't figure out how to delete it with my phone... Quote Share this post Link to post Share on other sites
saltyfish808 111 Report post Posted April 29, 2019 Beautiful sticks! They will look great in the 180! Also when it grows out, I would like to get a frag of that pink tip! Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted April 29, 2019 For sure. I will be a frag sharing SOB once the 180g goes up. A lot of room for fuzzy sticks! Hell, I might even have to trim back these frags in the 30g depending on how long this 180g build takes... Lol Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted February 19, 2020 It has been so long since I posted I think I forgot how...lol. Anyway, my sump was delivered yesterday. The 180g build is finally moving forward! 2020-02-19_12-00-16 by Jensen Esneault, on Flickr Quote Share this post Link to post Share on other sites
Smtwinn 84 Report post Posted February 21, 2020 On 2/19/2020 at 12:04 PM, RedStickReefer said: It has been so long since I posted I think I forgot how...lol. Anyway, my sump was delivered yesterday. The 180g build is finally moving forward! 2020-02-19_12-00-16 by Jensen Esneault, on Flickr water moving yet?! Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted February 21, 2020 Not yet. I'm not happy with the matte finish on the stand. I'm going to tape it off and put on a coat of semi-gloss this weekend. I ordered 3 Radion xr15s and a Vectra L2 pump yesterday, so I should be getting those in soon. I will order another 3 xr15s for a total of 6 once the tank gets cycled and further along. I plan on picking up some or most of the plumbing parts this weekend as well, so I can start working on the plumbing next weekend. I still need to determine how I'm going to plumb this sucker though. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted March 1, 2020 Some more progress made on the 180g this week. I got my vectra L2 and 3 radion xr15 G5 blues. My plan is to have a total of 6 xr15s over the 180g, but I might have an issue with mounting 2 xr15s in the middle of my tank due to my overflow box. I'll find out when I get the rms mounts in hand. I might have to use a single xr30, or come up with a new mounting solution for the xr15s in the middle of my tank. I painted the stand with semi-gloss paint this weekend. I just wasnt happy with the matte finish. I also bought most of the plumbing parts as well. I still need a spears gate valve for my drain piping and several ball valves though. I also made new sump drain line stand pipes. The ones that came with the sump did not use unions and were too tall for the limited space under my stand. I didnt make the stand, I only put on a new facade, so I'm stuck working with the space I've got. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted March 6, 2020 A very rough sketch on how I plan on doing the plumbing. We'll see if it works out this way. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted March 6, 2020 A quick update on the 30g frag tank...Unfortunately I'm going to have to start over with my SPS. Most of the SPS frags I had are dead due to AEFW. It's disheartening because I only bought SPS from reputable dealers that advertise they are "pest free". I did get two frags from Adam, but the two frags were fresh cut from healthy colonies, inspected, dipped in a concentrated solution of Bayer, and then inspected again before going into my 30g. There were no signs of any pests at all, so I know they didn't come from those two frags. Adult flatworms wouldn't have been able to survive the concentrated dip and there were no plugs or exposed coral bone for any eggs to come in on. All rock, sand and frag racks were removed from the tank. Small pieces of the few healthy surviving corals were cut, dipped in Bayer, glued to new plugs and put into a new frag rack. The few remaining corals are doing good and I haven't seen any signs of AEFW in months. I am struggling with keeping my nutrients up though because the tank is fishless. I'm thinking by pulling out all the sand and rock I removed the tank's biological filtration, which probably caused an ammonia spike and killed my fish. So, back to the drawing board. I'm looking forward to Aqua-fest to restock my SPS collection. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted March 9, 2020 I rented a par meter this weekend and my suspicion was confirmed. The remaining few sps in my 30g are recovering now that the AEFW are gone, but I could tell something else was wrong. My parameters are fine so I knew it wasnt that. My gen 1 radions are 10 years old and must be reaching the end of their life expectancy. They're still running fine, but the LEDs aren't putting out the par they used to. I had to crank up the intensity to 100% just to get a somewhat even spread of 250-300 par just 20 inches below the fixtures. The sps are now getting the par they need, so we'll see how they do from here. Oh, I also bought a yellow tang and added him to the tank. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted October 30, 2020 Been a while since I updated this build. The tank is up and running with about half of the scape complete. I'm still waiting on an additional 50 lbs of reef saver rock to be delivered. I only just recently got it running with salt and put the rock in so the water is still cloudy. I figured I'd go ahead and post these more recent pics and I'll have to take a few more updated pics of the sump/equipment to show where the tank is at currently. I plan on buying 3 more XR15s pretty soon to put over the tank. Plumbing by Jensen Esneault Sump area by Jensen Esneault Pump by Jensen Esneault 2020-10-30_09-57-50 by Jensen Esneault Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted November 2, 2020 A couple of updated pics. Sump is still a mess, but I'm still adding equipment. I'll clean up the wiring once I get it all in. 2020-11-02_03-36-37 by Jensen Esneault 2020-11-02_03-36-58 by Jensen Esneault 2020-11-02_03-37-17 by Jensen Esneault 1 Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted November 21, 2020 Evening blues on the 180g reef. So far I've added 3 azure damsels, a royal gramma and a starry blenny. Picking up a lamarck angelfish from AquaHut tomorrow. I also did a tiny bit of cable management in the sump area. I got all the plugs and controllers up off of the sump floor. Still need to deal with the nest of wires though. I plan on organizing it better once I get my Apex. Hopefully I can pick one up before the end of the year. Oh, I also added some wifi leds to the sump area for lighting. I can get some crazy colors going if I want. Lol. They aren't super bright, but it's enough to see. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted December 4, 2020 Happy birthday to me...picked up an apex. Also got my carx put together. Just need a regulator and probe to get it going. Quote Share this post Link to post Share on other sites
RedStickReefer 319 Report post Posted January 13 I just wanted to add some updated photos of the tank. I started adding a few corals yesterday, so we'll see how they do! 2021-01-13_03-00-02 by Jensen Esneault 2021-01-13_02-59-13 by Jensen Esneault 2021-01-13_02-59-31 by Jensen Esneault 2021-01-13_02-59-44 by Jensen Esneault Quote Share this post Link to post Share on other sites